Home Connection Equipment

Clamp for Tension Holding of a Home Connection - Automatic (self-tightening)

It is intended for home connections made by aerial bundle conductors: 2x16 mm2, 2x25 mm2, 4x16 mm2, 4x25 mm2. It is made of special materials, of very high mechanical strength resistant to all atmospheric influences. A modern structure enables reliable, easy and fast mounting under any weather conditions. The clamp is designed, tested and certified under the strictest requirements for this type of fixture. A benefit of this clamp over others is that it can be used also further tightening of the ABC even after the locking of wedges by simple pulling of the clamp. The conductors are additionally tightened (maximum 103 mm), therefore no automatic clip or Tirvit device is needed. During mounting, a cable or a piece of cable must be placed in all beds on the wedges.

Clamp for Tension Holding of Home Connection

It is intended for home connections made by aerial bundle conductors: 2x16 mm2, 2x25 mm2, 4x16 mm2, 4x25 mm2. It is made of special materials, of very high mechanical strength and resistance to all atmospheric influences. A modern structure enables reliable, easy and fast mounting under any weather conditions. The clamp is designed, tested and certified under the strictest requirements for this type of fixture. It is used for mounting single-phase and three-phase home connections. During mounting of a single-phase home connection, a cable or a piece of cable most be placed in the second wedge, for the purpose of force balancing.

RA 25 Angle Clamp for Home Connection

It is used in changing the LV ABC direction in a home connection. It is designed to carry 2 or 4 insulated conductors of maximum cross-section 4x25 mm2. It consists of clamp body and suspension stirrups. The body of the clamp is made of a polyamide of high mechanical strength. For fixing of the ABC to the clamp, we recommend

Clamp for Tension Holding of the LV ABC without Bearing Conductor 2-4x16-25

The clamp is intended for the tension holding of two or four insulated conductors. It is used for mounting of the distribution lines of smaller cross-sections, and for tightening of conductors for home connections. It is made of high quality materials, of great mechanical strength, resistant to all atmospheric influences.

Clamp for Tension Holding of the LV ABC without Bearing Conductor

It is used for the tension holding of the low voltage aerial bundle conductors without bearing conductor. The insulation pad is made of polyamide reinforced by glass fibers, which provides good tensile strength. The main elements of the structure are made of galvanized steel.

PA 621 (200daN) Clamp for Tension Holding

It is used for the tension holding of one insulated conductor, of diameter ranging from 6 to 21 mm. It is made of a polymer reinforced by glass fibers resistant to weather conditions and UV rays. Its modern structure enables reliable, easy and fast mounting under any weather.